Vase clamping set 200mm wide is ideal for adding a support onto a vase with a large opening.
Once inserted into the vase the arms will open and hold on the inside walls of the vase.
Comes complete with a 200mm long allthread rod which allows for the addition of a side entry cable fitting or lampholder on the top.
Please note - This does NOT include the vase top, side entry cord grip or lampholder.
Method of use.
Do a check to make sure the armed fitting is right for your vase.
Hold the allthread rod with the arm fitting at the bottom.
Insert the fitting into your vase and ensure the arms will open and grasp the side of the vase when slowly pulling the allthread upwards.
The arms should now grip onto the inside wall.
Remove the fitting by lowering it into the vase and if needed carefully turn the vase upside down, remover the complete fitting.
Add your vase top onto the allthread and either a side entry cord grip or the base of a lampholder on top.
Ensure this vase top fits and looks ok on top of your vase.
Carefully place the bottom of the vase fixing inside the vase allowing the arms to open. Carefully pull the Brass top fitting up to ensure the arms have opened.
Tighten up the top fitting fitting which will screw the allthread down into the arms and therefore tighten the complete fitting in place.
Once inserted into the vase the arms will open and hold on the inside walls of the vase.
Comes complete with a 200mm long allthread rod which allows for the addition of a side entry cable fitting or lampholder on the top.
Please note - This does NOT include the vase top, side entry cord grip or lampholder.
Method of use.
Do a check to make sure the armed fitting is right for your vase.
Hold the allthread rod with the arm fitting at the bottom.
Insert the fitting into your vase and ensure the arms will open and grasp the side of the vase when slowly pulling the allthread upwards.
The arms should now grip onto the inside wall.
Remove the fitting by lowering it into the vase and if needed carefully turn the vase upside down, remover the complete fitting.
Add your vase top onto the allthread and either a side entry cord grip or the base of a lampholder on top.
Ensure this vase top fits and looks ok on top of your vase.
Carefully place the bottom of the vase fixing inside the vase allowing the arms to open. Carefully pull the Brass top fitting up to ensure the arms have opened.
Tighten up the top fitting fitting which will screw the allthread down into the arms and therefore tighten the complete fitting in place.